Traffic Radar Accessories.
Attach, Connect, Align and Test.

smartmicro has developed a wide range of accessories to provide interfacing to intersection or pole cabinets, to simplify installation, facilitate alignment and test etc. Among those are cabinet cards, brackets, cables, target simulators and more.

Third party equipment like field controllers, cables, communication modules etc. are certified by smartmicro, recommended models are listed, test reports are available on request. 


To protect the sensor radome surface form accumulation of rain droplets, snow or ice.
Download data sheet (pdf).


Show moreClose


In order to mount and adjust sensors a wide range of brackets can be used.
Download data sheet (pdf).


Show moreClose

Cables and Junction Boxes

The smartmicro Junction Box offers a universal and easy to use field installable way of
connecting and surge protecting to the home run cable.

Download data sheet (pdf)


Show moreClose

2nd Generation TMIB Cabinet Card

The Smartmicro Traffic Management Interface Board (TMIB) connects up to four UMRR Radar sensors to NEMA TS1 or TS2 cabinets (rack mount version); or to other traffic controllers (shelf mount version).

A TMIB set consists of two boards. The TMIB_AB assembly is the control board plus the interface board. This second board contains all surge and overvoltage protection circuitry for four long cables to four sensors, as it is typically the case on an intersection. One TMIB set can replace up to 16 inductive loops (TS1 usage) or up to 64 inductive loops (TS2 SDLC usage, up to four TS2 BIUs replaced).


The data of all four Radar sensors can be accessed conveniently through one single 100Base TX Ethernet interface.

Download 2nd Generation data sheet (pdf) (for UMRR-0C and UMRR-11)

Show moreClose

Relay Interface

The Sensor Relay Option (SRO) module supports any application which requires contact closures attached to the sensor. It features 8 configurable solid state relays which can be chosen as either normally-open (NO) or normally-closed (NC).

Download data sheet (pdf)

Show moreClose

Communication Modules

In order to enable wired or wireless network operation smartmicro has certified the following communication modules.

  • Moxa NPort 5150a
  • Moxa OnCell G3150
  • Moxa UPort 1150


Show moreClose

Alignment and Installation Tools


The EKTSDG-010101 (Elektronic K-band Target Simulator/ Doppler Generator) is a battery powered handheld portable moving target simulator for K-band (24GHz) Radar sensors. 
It can be used for:

  • alignment of sensors in the field at installation time
  • field or lab calibration and year-by-year inspection
  • general functional testing in the field and in the lab.

This device was specifically developed to work with Smartmicro 24GHz sensors. It is capable to simulate a moving target in distances up to 100m and can for instance be placed close to a stop line of an intersection to check the alignment of one or multiple radar sensors.
A software generated modulation signal allows generation of low distortion and directional Doppler signals from 44Hz to 13,4kHz corresponding to any speeds from 1km/h to 300km/h.

Download data sheet (pdf)

Download setup software


Show moreClose